Haier HSU-15LQA13 ユーザーズマニュアル

Operation

1.After unit starts, select your desired operation mode.

2.Press TIMER button to change TIMER mode. Every

time the button is pressed, display changes as follows:

Remote controller:

BLANK

TIMER ON TIMER OFF

TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON or

TIMER OFF or TIMER ON-OFF). "        "or "       "will flash.

3.Press        /  

button to set time.

It can be adjusted within 24 hours.

Hints:
After replacing batteries or a power failure happens, time
setting should be reset.

According to the Time setting sequence of TIMER ON or

1.Press          to starting

Setting the comfort work conditions.

2.The setting of healthy airflow function

TIMER OFF-ON

0.5h

0.5h

0.5h

0.5h

Press the button for each time, setting time in the first 
12 hours increased by 0.5 hour every time, after 12 
hours,increased by 1 hour every time.

Press the button for each time, settiing time in the first 
12 hours decreased by 0.5 hour every time, after 12 
hours,decreased by 1 hour every time.

After adjust the time,press              button and confirm the

time ON or OFF button will not flash any more.

4.Confirm timer setting

5.Cancel timer setting

Press the timer button by times until the  time display 

eliminated.

         Press button to select “ Healthy airflow”, the remote

         

         controller will switch as below 

Healthy 

airflow 

upwarder

Healthy 

airflow 

downwarder

fixed

 

location

Note:

1.After setting the healthy airflow function, the position 

 grill is fixed.

3.In cooling and dry, using the air conditioner for a long 

time under the high air humidity, condensate water may

occur at the grille .

Notice: Do not direct the flap by hand. Otherwise, the
grille will run incorrectly. If the grille is not run correctly, 

stop  for a minute and then start, adjusting by remote 

controller.

2.In cooling, it is better to select the 

mode.

5

TIMER OFF, either Start-Stop or Stop-Start can be 

achieved.