Philips DS9860W/10 ユーザーズマニュアル

Connect your Wi-Fi enabled device to

your existing home Wi-Fi network.

Launch the Internet browser (for example,

Apple Safari or Microsoft Internet

Explorer) on your Wi-Fi enabled device.

Open the configuration page of your

home Wi-Fi router.

Find the Wi-Fi settings tab and write down

the following information on paper:
A

Network name (SSID)

Wi-Fi security mode (usually WEP,

WPA or WPA2 if enabled)

Wi-Fi password (if Wi-Fi security is

enabled)

DHCP mode (enabled or disabled)

Static IP address settings (if DHCP

mode is disabled)

Switch DS9860W to Assisted Wi-Fi

Setup mode

• After successful boot-up (see 'Turn

DS9860W on' on page 8), press and hold

WI-FI SETUP on the back of the main

speaker.

The WI-FI STATUS indicator blinks

green and yellow alternately.

A new Wi-Fi network of DS9860W

itself is created, with the network name

(SSID) of Philips_Install XXXXXX.

It takes about 45 seconds for successful

creation of this new Wi-Fi network.

Note

•

After you finish manual Wi-Fi setting for DS9860W, this

new Wi-Fi network disappears.

•

If you fail to enter Assisted Wi-Fi Setup mode, power

off DS9860W and power on it, then try again after

successful boot-up.

•

Make sure that there are no other Philips AirPlay-

enabled devices in Assisted Wi-Fi Setup mode at the

same time. Multiple new Wi-Fi networks created this

way may interfere with each other.

Connect your Wi-Fi enabled device to

the newly created Wi-Fi network

The new Wi-Fi network created by DS9860W

only allows access of one Wi-Fi enabled device.

To avoid interference from any other Wi-Fi

devices, you are recommended to temporarily

disable the Wi-Fi function on your other Wi-Fi

devices.

Option 1: Use your iPod touch/iPhone/iPad

Select Settings -> Wi-Fi on your iPod

touch/iPhone/iPad.

Select Philips_Install XXXXXX from the

list of available networks.