Philips WAK3300/05 ユーザーズマニュアル

2

Mains plug
This apparatus is fitted with an approved 13 
Amp plug. To change a fuse in this type of 
plug, proceed as follows:

Remove fuse cover and fuse.

Fix the new fuse which should be a BS1362 
5-Amp, A.S.T.A. or BSI approved type.

Refit the fuse cover.
If the fitted plug is not suitable for your socket 
outlets, it should be cut off and an appropriate 
plug fitted in its place.
If the mains plug contains a fuse, it should 
have a value of 5 Amp. If a plug without a fuse 
is used, the fuse at the distribution board 
should not be greater than 5 Amp.
Note: The severed plug must be disposed, so as 
to avoid a possible shock hazard due to it being 
inserted into another 13-Amp socket.

How to connect a plug
The wires in the mains lead are coloured using 
the following codes: blue = neutral (N), 
brown = live (L).

O

As these colours may not correspond with 
the colour markings identifying the terminals in 
your plug, proceed as follows:
– Connect the blue wire to the terminal 

marked N or coloured black.

– Connect the brown wire to the terminal 

marked L or coloured red.

– Do not connect either wire to the earth 

terminal in the plug, marked E (or e) or 

coloured green (or green and yellow).

Before replacing the plug cover, make sure 
that the cord grip is clamped over the sheath 
of the lead, and not simply over the two wires.

Copyright in the U.K.
Recording and playback of any materials may 
require consent. See Copyright Act 1956 and 
The Performer’s Protection Acts 1958 to 1972.

Typeskilt finnes på apparatens bakside.

For å redusere faren for brann eller 
elektrisk støt, skal apparatet ikke utsettes 
for regn eller fuktighet.