Philips LFF6050W/GBB ユーザーズマニュアル

- 76 -

When a paper jam occurs, the following message 
appears:

1 Open the document feeder scanner cover.

2 Remove the jammed paper without tearing it.
3 Close the document feeder scanner cover.

4 Press 

.

When turning on the terminal, nothing is displayed on 
the screen.
Check the connection between the power cord and the 
outlet.

appears on the screen.

1 Remove the document or press button 

.

2 Check the thickness of the document (50 sheets of 

paper of 80 g/m2).

3 Iron out the sheets if needed.
4 Help the sheets along.

1 Check that the telephone line cable is correctly 

plugged in.

2 Check that there is a tone signal on the telephone 

line by means of the button

 

 .

1 Make a photocopy of a document; if it is correct 

then your fax is functioning normally. 

2 Call back the subscriber and have him / her resend 

the document. It was probably sent with the sheet 
inserted backwards.

1 Check that the telephone line cable is correctly 

plugged in.

2 Check the tone by pressing the button 

.

3 Check the prefix is correctly programmed and 

used.

If the communication fails, the terminal advises you of an 
automatic retry later.
Example of what is displayed:

You have the choice between:
• waiting until the transmission takes place at the given 

time,

• restarting the transmission immediately by 

pressing 

,

• abandoning transmission by pressing 

. To eject 

the document, press 

 again.

You have the choice between:
• waiting until the transmission takes place at the given 

time,

• restarting the transmission using the transmission 

queue. In this case, for a document composed of 
several pages, the transmission will take place from 
the page where the error occurred (see Performing 
immediate transmission from the waiting queue, 
page 26),

• abandoning the transmission by deleting the 

corresponding command in the transmission line (see 
Deleting a transmission on hold, page 27).

The terminal makes at most 5 automatic redials. The non-
transmitted document is automatically deleted from the 
memory and a transmission report is then printed together 
with an error code and the cause for transmission failure 
(see the communication error codes).

The communication error codes appear in the logs and 
transmission reports.

Code 01 - Busy or no fax answer
This code appears after 6 unsatisfactory attempts. Call 
later.
Code 03 - User break
A communication has been stopped by the user pressing 

the button 

.

Code 04 - Non programmed number
A number saved as a one-touch key or abbreviated 
number is not valid, check it. (Example: a delayed 
transmission was programmed with a one-touch key and 
this key has been deleted in the meantime).
Code 05 - Scanning default
An incident occurred with the scanner, for example, the 
sheet is jammed.

Current time

Time of next try