Electrolux E23BC68JSS オーナーマニュアル

Your refrigerator is equipped with separate water and 
air filtering systems. The water filter system filters all the 
water used to produce ice. The air filter removes odors 
and impurities from the refrigerator compartment.

The control panel includes controls to monitor the 
status of your water and air filters. See the Controls 
section for more information.

The 

TM 

NGFC-2000 filter 

system is tested and certified  by NSF 
International to NSF/ANSI Standards
42 and 53 for the reduction of claims 
specified on the performance data sheet. 

Do not use with water that is microbiologically unsafe 
or of unknown quality without adequate disinfection 
before or after the system. Systems certified for cyst 
reduction may be used on disinfected waters that may 
contain filterable cysts. 

 •  Rated Capacity - 240 gallons
 •  Rated service flow - .5 gallons per minute
 •  Maximum Rated Pressure - 100 pounds per

square inch

 •  Recommended Minimum Operating Pressure:

30 pounds per square inch

 •  Operating Temp.: Min. 33°F, Max. 100°F

The water filter is located at the lower left side of the 
fresh food compartment. 

In general, you should change the water filter every six 
(6) months to ensure the highest possible water quality. 
The 

Water Filter Status light on the Touch Panel 

prompts you to replace the filter after the 6 month time 
period has elasped. The water filter status light on this 
model is not performance tested or certified by NSF.

If your refrigerator has not been used for a period of 
time (during moving for example), change the filter 
before reinstalling the refrigerator.

It is not necessary to turn the water supply off to 
change the filter. Be ready to wipe up any small 
amounts of water released during the filter replacement.

 

1   Push the filter release button above the cartridge 

to disconnect it.

 

2  Slide the old water filter cartridge straight out of 

the housing and discard it.

 

3  Unpack the new filter cartridge and remove the 

two (2) protective caps covering the inlet and exit 
of the filter.  Slide the filter gently into the housing 
until it stops against the snap-in connector at the 
back of the housing.