Electrolux E23BC68JSS オーナーマニュアル

ページ / 30
28
Solutions to Common Problems
Refrigerator Operations
Concern
Potential Cause
Common Solution
Compressor does not 
run.
Cooling system is turned Off. 
Refrigerator is in defrost cycle. 
Plug at wall outlet is disconnected.
House fuse is blown or a tripped circuit 
breaker.
Power outage.
Electronic control system keeps the 
refrigerator at a constant  temperature.
Turn cooling system On. See Controls Section for 
location of cooling system On/Off button.
This is normal for a fully automatic defrost refrigerator. 
The defrost cycle occurs periodically, lasting about 30 
minutes.
Ensure plug is tightly pushed into outlet.
Check/replace fuse with a 15 amp time-delay fuse.  
Reset circuit breaker.
Check house lights. Call local Electric Company.
This is normal. Refrigerator goes on and off to keep 
temperature constant.
Refrigerator runs too 
much or too long.
Room or outside weather is hot.
Refrigerator has recently been disconnected 
for a period of time.
Automatic ice maker is operating.
Doors are opened too frequently or too long.
Refrigerator/freezer door may be slightly 
open. 
Freezer control is set too cold (control found 
on side of left hand door).
Fresh food/freezer gasket is dirty, worn, 
cracked, or poorly fitted.
This model is provided with a high-efficiency, 
variable-speed compressor.
It’s normal for the refrigerator to work longer under 
these conditions.
It takes 8-12 hours for the refrigerator to cool down 
completely.
Ice maker operation causes refrigerator to run slightly 
more.
Warm air entering the refrigerator causes it to run more. 
Open doors less often.
Ensure refrigerator is level. Keep food and containers 
from blocking door. See Concern section, Opening/ 
Closing of Doors/ Drawers.
Set freezer control to warmer setting until refrigerator 
temperature is satisfactory. Allow 24 hours for 
temperature to stabilize.
Clean or change gasket. Leaks in door seal will cause 
refrigerator to run longer in order to maintain desired 
temperatures.
It is normal for the compressor to run for long periods 
of time, instead of starting and stopping frequently.
Digital temperature 
displays are flashing.
Electronic control system has detected a 
performance problem.
Call  your Electrolux service representative, who can 
interpret any messages or number codes flashing on 
the digital displays.
Temperatures Are Too Cold
Concern
Potential Cause
Common Solution
Freezer temperature 
too cold. Refrigerator 
temperature is 
satisfactory.
Fast Freeze function is activated.
Freezer control is set too cold.
Ice maker is on.
Fast Ice function is activated.
Deactivate Fast Freeze function.
Set freezer control to a warmer setting. Allow 24 hours 
for temperature to stabilize.
It is normal for the freezer compartment to over cool 
while automatic ice maker is on.
Deactivate Fast Ice function.
Refrigerator temperature 
too cold. Freezer 
temperature is 
satisfactory.
Refrigerator control is set too cold.
Set refrigerator control to a warmer setting. Allow 24 
hours for temperature to stabilize.
Food stored in drawers 
freezes.
Refrigerator control is set too cold.
See solution above.
Food stored in Cool Zone  
freezes (select models).
Cool Zone temperature control is set too cold.
Adjust Cool Zone temperature control to a warmer 
setting. Meat should be stored at a temperature just 
below the freezing point for maximum fresh storage 
time. It is normal for ice crystals to form due to the 
moisture content of meat.