Snapper ZM5201M ユーザーズマニュアル

 

3.3.3.   RIDING MOWER - LUBRICATION 
1.  Front Wheel Bearings 
Lubricate with Kendall NLGI No. 2 lithium grease or 
equivalent, from a grease gun.  See Figure 3.5. 

 

 

 

2. Transaxle 
Check the level of fluid in both of the fluid reservoirs. 
Wipe away all dirt and debris from around reservoir 
cap before removing. Oil must remain absolutely 
clean! Check with machine on a level surface with 
engine “OFF”. Fill reservoir as needed to bring level 
up to 1-1/2 inches below the top of the filler neck.  
Use clean, fresh premium hydraulic oil having a 
viscosity equivalent to SAE 20W20, SAE 30 or SAE40. 
The fluid should be chemically stable, incorporating 
rust and oxidation inhibitors. Make sure funnels, 
pouring spouts and oil can are completely clean. 
Reinstall reservoir cap. See Figure 3.6. IMPORTANT: 
DO NOT remove or service the transaxle fluid filters. 
This service should be made periodically by an 
authorized SNAPPER dealer. See the service 
schedule to determine the recommended change 
interval. 
 
 

 

3.  Power Transfer Shaft 
Lubricate power transfer shaft with Kendall NLGI 
No. 2 lithium grease or equivalent, from a grease 
gun.  See Figure 3.7. 

 

 

 

4.  OTHER LUBRICATION POINTS 
Lubricate machine caster wheel shafts, all belt drive 
idler arm pivots (deck, transmission & PTO), and 
deck lift arm (right side under frame) with Kendall 
NLGI No. 2 lithium grease or equivalent, from a 
grease gun. 

 
3.4  BEFORE OPERATING MACHINE 
1.  Clean all dirt and debris from around the two 
hydraulic fluid reservoirs. Especially around the top and 
cap area. 
2.  Clean all dirt and debris from the cooling fins on the 
engine and from both hydraulic pumps. 

 

3.5  ANNUALLY (END OF EACH SEASON) 
Perform all maintenance as described in Section 
“AFTER EVERY 25 OPERATING HOURS”. 
 

3.5.1. ENGINE 
Service engine according to engine owner’s 
manual. 

 

(Continued on next Page)