Empire Comfort Systems DVX36DP31(N,P)-1 ユーザーズマニュアル

25613-0-0309

Page 47

1.   Stop! Read the safety information above.

2.  Set REMOTE/OFF/ON switch to OFF.

3.  Turn off all electric power to the appliance (if applicable).

4.  Lower bottom louver assembly.

5.  P u s h   i n   g a s   c o n t r o l   k n o b   s l i g h t l y   a n d 

turn clockwise 

 to "OFF." 

 

Note: Knob cannot be turned from "PILOT" to "OFF" unless 

knob is pushed in slightly. Do not force.

6.   Wait ten (10) minutes to clear out any gas. Then smell for 

gas, including near the floor. If you then smell gas, STOP! 

Follow "B" in the safety information above. If you do not 

smell gas, go to the next step.

7.   Find pilot - Follow metal tube from 

gas control. The pilot is behind the 

burner on the right side.

8.   Turn gas control knob counterclockwise 

 to "PILOT."

9.   Push in control knob all the way and hold in. Repeatedly 

push the piezo ignitor button until the pilot is lit. Continue 

to hold the control knob in the for about one (1) minute after 

the pilot is lit. Release knob, and it will pop back up. Pilot 

should remain lit. If it goes out, repeat steps 5 through 9.

•  If the control knob does not pop up when released, STOP 

and IMMEDIATELY call a qualified service technician or 

gas supplier. 

•  If the pilot will not stay lit after several tries, turn the gas 

control knob to "OFF" and call your service technician or 

gas supplier. 

10.  Turn  gas  control  knob  counterclockwise 

    to 

"ON." 

11.  Close bottom louver assembly.

12.  Turn on all electric power to the appliance (if applicable).

13.  Set REMOTE/OFF/ON switch to desired setting. 

A.   This appliance has a pilot which must be lighted by hand. 

When lighting the pilot, follow these instructions exactly.

B.   Before lighting smell all around the appliance area for gas. 

Be sure to smell next to the floor because some gas is heavier 

than air and will settle on the floor.

 

What To Do If You Smell Gas

•  Do not try to light any appliance.

•  Do not touch any electrical switch; 

•  Do not use any phone in your building.

•  Immediately call your gas supplier from a neighbor's 

phone. Follow the gas supplier's instructions.

•  If  you  cannot  reach  your  gas  supplier,  call  the  fire 

department.

C.   Use only your hand to push in or turn the gas control knob. 

Never use tools. If the knob will not push in or turn by hand, 

don't try to repair it; call a qualified service technician. Force 

or attempted repair may result in a fire or explosion.

D.   Do not use this appliance if any part has been under water. 

Immediately call a qualified service technician to inspect the 

appliance and to replace any part of the control system and 

any gas control which has been under water.

1.   Set REMOTE/OFF/ON switch to OFF.

2.   Turn off all electric power to the appliance if service is to 

be performed (if applicable).

3.   Lower bottom louver assembly.

4.   Push in gas control knob slightly and turn clockwise 

 to "OFF." Do not force.

5.  Close bottom louver assembly.

THERMOCOUPLE

ELECTRODE

PILOT

THERMOPILE

GAS CONTROL KNOB SHOWN
IN “OFF” POSITION

REMOTE

OFF

ON

FOR YOUR SAFETY, READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property 

damage, personal injury or loss of life.

LIGHTING INSTRUCTIONS

TO TURN OFF GAS TO FIREPLACE