Husqvarna 445 EPA II ユーザーズマニュアル
2
–
English
KEY
T
O SYMBOLS
Symbols on the mac
hine:
W
ARNING! Chain saws can be dangerous!
Careless or improper use can result in serious
or fatal injury to the operator or others.
or fatal injury to the operator or others.
Please read the operator’s manual carefully
and make sure you understand the
instructions before using the machine.
and make sure you understand the
instructions before using the machine.
Always wear:
•
Approved protective helmet
•
Approved hearing protection
•
Protective goggles or a visor
Both of the operator
′
s hands must be used to
operate the chain saw.
Ne
ver operate a chain saw holding it with one
hand only.
Contact of the guide bar tip with an
y object
must be avoided.
Tip contact may cause the guide bar to move
suddenly upward and backward (so-called
kickback), which may cause serious injury.
suddenly upward and backward (so-called
kickback), which may cause serious injury.
Other symbols/decals on the mac
hine refer to special
certification requirements for certain markets.
Symbols in the operator’
s manual:
Switch off the engine bef
ore carrying out
any checks or maintenance. CAUTION!
The stop switch automatically returns to
the start position. In order to prevent
unintentional starting, the spark plug cap
must be removed from the spark plug when assembling,
checking and/or performing maintenance.
The stop switch automatically returns to
the start position. In order to prevent
unintentional starting, the spark plug cap
must be removed from the spark plug when assembling,
checking and/or performing maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual chec
k.
Protectiv
e goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil fl
ow.
The chain br
ake must be engaged when the
chain saw is started.
You will find the following labels on your chain saw:
EP
A II
The Emissions Compliance P
eriod referred to on the
Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
devices and system may be performed by any nonroad
engine repair establishment or individual.