Husqvarna 445 EPA II ユーザーズマニュアル

32 – 

English

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm (12 inches) and hook it 
into the notch in the rim of the pulley. Release the recoil 
spring by letting the pulley rotate slowly backwards.

•

Undo the bolt in the centre of the pulley and remove the 
drive disc (A), drive disc spring (B) and the pulley (C). 
Insert and secure a new starter cord in the starter pulley. 
Wind approx. 3 turns of the starter cord on the starter 
pulley. Fit the starter pulley so that the end of the recoil 
spring (D) hooks into the starter pulley. Now assemble the 
drive disc spring, drive disc and the bolt in the centre of the 
pulley. Carry the starter cord through the hole in the 
starter housing and the starter handle. Tie a good knot on 
the starter cord.

•

Hook the starter cord in the notch in the pulley and turn the 
starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned an additional 1/
2 turn when the starter cord is pulled all the way out.

Stretch the line with the handle. Move your thumb and release 
the line. See the figure below.

•

Lift up the starter pulley. See instructions under the 
heading Changing a broken or worn starter cord. 
Remember that the recoil spring is coiled under tension in 
the starter housing.

•

Remove the cassette with the recoil spring from the 
starter.

•

Lubricate the recoil spring with light oil. Fit the cassette 
with recoil spring in the starter. Fit the starter pulley and 
tension the recoil spring.

•

Undo the bolt in the centre of the pulley and remove the 
drive disc and the drive disc spring.

•

Replace the drive disc spring and fit the drive disc above 
the spring.