Snapper ZM5201M ユーザーズマニュアル

 

1.  Front Wheel Bearings 
Lubricate with Kendall NLGI No. 2 lithium 
grease or equivalent, from a grease gun.  
See Figure 3.5. 

 

2. Transaxle 
Check the level of fluid in both of the fluid 
reservoirs. Wipe away all dirt and debris from 
around reservoir cap before removing. Oil 
must remain absolutely clean! Check with 
machine on a level surface with engine 
“OFF”. Engage park brake. Fill reservoir as 
needed to bring level up to 1-1/2 inches 
below the top of the filler neck.  Use clean, 
fresh premium hydraulic oil having a viscosity 
equivalent to SAE 20W20, SAE30 or SAE40. 
The fluid should be chemically stable, 
incorporating rust and oxidation inhibitors. 
Make sure funnels, pouring spouts and oil can 
are completely clean. Reinstall reservoir cap. 
See Figure 3.6. IMPORTANT: DO NOT 
remove or service the transaxle fluid filters. 
This service should be made periodically by 
an authorized SNAPPER dealer. See the 
service schedule to determine the 
recommended change interval. 
 
 

 

 
 
 
 
 

3.  Power Transfer Shaft 
Lubricate power transfer shaft with Kendall 
NLGI No. 2 lithium grease or equivalent, 
from a grease gun.  See Figure 3.7. 

 

 

 

4.  OTHER LUBRICATION POINTS 
Lubricate machine caster wheel shafts, 
traction drive shaft and mower deck idler 
arm with Kendall NLGI No. 2 lithium grease 
or equivalent, from a grease gun. 

 
3.4  BEFORE OPERATING MACHINE 

1. Clean all dirt and debris from around the two 
hydraulic fluid reservoirs. Especially around the top 
and cap area. 
2.  Clean all dirt and debris from the cooling fins on 
the engine and from both hydraulic pumps. 
 

Perform all maintenance as described in Section 
“AFTER EVERY 25 OPERATING HOURS”. 
3.5.1. ENGINE 
Service engine according to engine owner’s manual. 

 

(Continued on next Page)