Snapper SPE140KW ユーザーズマニュアル

 

Should it become necessary to replace the transmission 
drive belt, contact an authorized SNAPPER Dealer for 
service. 
 

 
1.  Disconnect idler arm spring. 
2.  Remove existing belt. Replace with new belt, part 

no. 2-9118. 

3.  Reconnect idler arm spring. See Figure 7.1. 
 

 

 

 

7.2.1.  TRACTION BELT REMOVAL 
1.  STOP ENGINE!  Remove two wing-nuts retaining 

fender.  Remove fender.  See Figure 7.2. 

2.  Remove Traction Belt from Wheel Pulley first by 

running Belt off as Wheel is turned. Remove belt 
from Transmission output Pulley next. 

3.  Lay new Traction Belt part no. 4-6240 flat on ground 

(around tire) and roll Mower Wheel over Traction Belt, 
removing Traction Belt from machine. 

 
7.2.2.  TRACTION BELT INSTALLATION 
1.  STOP ENGINE!  Lay Traction Belt flat on ground in 

front of Traction Wheel, roll Traction Wheel over 
Traction Belt until wheel is in middle of belt. 

2.  Place Traction Belt on Wheel Pulley followed by 

Transmission Output Pulley.   

3.  Reinstall Fender and tighten two wing-nuts. 
4.  Adjust Traction Rod and Brake Rod as necessary.  

Refer to Section “ADJUSTMENTS - 
STEERING/BRAKES and TRACTION 
LEVERS/RODS”. 

 

 

INSTALLATION 

1.  Remove mower deck belt cover. 
2.  Remove idler spring and swing idler away from belt. 
3.  Remove old belt from spindle pulleys and electric 

clutch pulley. 

4.  Route new belt, part number 3-5710 for 36” Deck & 

2-9261 for 48” Deck around spindle pulleys. 

NOTE: 36” Deck Belt also connects to electric clutch. 
5.  Move idler to belt and re-attach tension spring. 
6.  For 48” Deck to electric clutch use belt 2-9262. 
 
 

 

FIGURE 7.3