Chaparral Chaparral FS 1310 ユーザーズマニュアル

You must use the proper SCSI cables on the model you purchased. For example, if you 
purchased the LVD model, you must use LVD-qualified SCSI cables. Symbols on the rear 
panel tell you which model you have.

LVD/SE (wide, Ultra-2 SCSI), 
68-pin SCSI (LVD/SE model)

Ultra wide, 68-pin SCSI (HVD model)

The router must be turned off.

Turn off the SCSI devices you want to connect.

Connect one end of a SCSI cable to a SCSI channels on the back of the router.

See 

. 

Connect the other end of the SCSI cable to the SCSI device.

Make sure each device on the SCSI bus has a unique address (the FS1310 uses 
address 7 by default).

Make sure that each channel is properly terminated.

Termination on the LVD/SE model is always enabled at the router. You must also 
terminate the SCSI bus at the device end.

Termination on the HVD model can be disabled for operation in the middle of the bus.

You can connect the router directly to an FC HBA or to an FC switch or hub. You must use 
proper FC components (for example, GBICs, media interface adapters [MIAs], and FC 
cable, either optical or copper). Contact Chaparral for information on components tested by 
Chaparral and advice on attaching SCSI devices in an optimal manner for your applications.

You will need to purchase a GBIC through your distributor. The GBIC connector is 
available in four different versions: 

!

Copper (Active)

–

DB-9

–

HSSDC

!

Optical

–

Short  wave

–

Long wave

SCSI

LVD/SE

SCSI

DIFF