Zenoah HEZ2500F ユーザーズマニュアル

■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the clutch

housing and rotate it by hand to check that the
driveshaft is engaged with the gears.

2. Insert the driveshaft housing into the clutch housing

until it bottoms, and align the positioning holes on
the clutch housing and the shaft tube and install the
screw. When difficult to engage, twist the engine
slightly.

3. Fasten the clamp securely with two screws.

Tighten the screws(1) gradually by turns.
Tightning Torque: 44~70in-lbs (5~8N.m.)

■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on

the top of the carburetor. (SE2)

■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine and

the main unit. Pair the wires of the same color.

■ MOUNTING OTHER PARTS 
1. Insert the driveshaft into the clutch drum, then attach

the gearbox to the shaft tube as aligning the
positioning holes and fasten the screw (A). Fasten
the clamp bolt (B) firmly. (SE3)

2. Install the handle to the shaft tube and clamp at a

position best for your job. (SE4)