Husqvarna 335RJ ユーザーズマニュアル

ページ / 32
12 – 
English
ASSEMBLY
Fitting a blade guard, grass blade 
and grass cutter
Hook the blade guard/combination guard (A) onto the 
fitting on the shaft and secure with the bolt. CAUTION!  
Ensure that the guard extension is removed.
Use the recommended blade guard. See the Technical 
data section.
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
Place the blade (D), support cup (E) and support flange 
(F) on the output shaft.
Fit the nut (G). The nut must be tightened to a torque of 
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool 
kit. Hold the shaft of the spanner as close to the blade 
guard as possible. To tighten the nut, turn the spanner in 
the opposite direction to the direction of rotation (Caution! 
left-hand thread). 
Fitting other guards and cutting 
attachments
Fit the trimmer guard/combination guard (A) intended for 
use with the trimmer head/plastic blades. CAUTION!  
Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the two 
hooks on the plate holder (M). Bend the guard around the 
shaft and tighten it with the bolt (L) on the opposite side of 
the shaft. Use the locking pin (C). Place the locking pin in 
the groove on the screw head and tighten. See diagram.
Fit the drive disc (B) on the output shaft. 
Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.
To dismantle, follow the instructions in the reverse order.
G
F
D
B
C
A
E
A
A
L
C
M
B
A
M
L
H