Guardian Technologies 004451 (12,500 WATT) ユーザーズマニュアル

Read the Owner’s Manual and  Safety Rules before
operating this generator.
Compare the generator to this illustration to become familiarized

with the locations of various controls and adjustments.  Save this

manual for future reference.

1)  12 Volt DC, 10 Amp Receptacle –

This receptacle

allows the capability to recharge a 12 volt DC storage battery

with provided battery charge cables.

2)  120 Volt AC, 20 Amp, Duplex Receptacle – 

Supplies

electrical power for the operation of 120 Volt AC, 20 Amp, 

single-phase, 60 Hz electrical lighting, appliance, tool and 

motor loads.

3)  120 Volt AC, 20A Duplex GFCI Receptacle – 

Supplies ground fault protected electrical power for

operation of 120 volt AC 20 amp, single-phase, 60 Hz electric

lighting, appliances, tools and motor loads.

4) 120 Volt AC, 30 Amp Locking Receptacle –

Supplies

electrical power for the operation of 120 Volt AC, 30 Amp,

single-phase, 60 Hz electrical lighting, appliance, tool and

motor loads.

5)  120/240 Volt AC, 30 Amp Locking Receptacle –

Supplies electrical power for the operation of 120 and/or 240

Volt AC, 30 Amp, single-phase, 60 Hz, electrical lighting,

appliance, tool and motor loads.

6)  120/240 Volt AC, 50 Amp Receptacle – 

Supplies

electrical power for the operation of 120/240 Volt AC, 50

Amp, single-phase, 60 Hz, welder or motor loads.

Cleaner –

Filters intake air as it is drawn into the engine.

8) Choke Knob –

Used when starting a cold engine.

9)  Winter / Summer Valve –

See “Cold Weather Operation.”

(Section 2, page 12.)

(AC) – Each receptacle is provided with

a push-to-reset circuit breaker to protect the generator

against electrical overload. (50 amp uses toggle reset)

11) Fuel Tank – 

Tank holds 16 U.S. gallons of fuel.

12) Grounding Lug –

Ground the generator to an approved

earth ground here.  See page 9 for details.

13) Idle Control Switch –

The idle control runs the engine at

normal (high) speeds when there is an electrical load present

and runs the engine at idle (low) speeds when a load is not

present.