Epson V700 保証情報
4
■
Unplug the scanner and the AC adapter before cleaning. Clean with a damp cloth
only. Do not use liquid or aerosol cleaners. Do not apply any liquid directly on the
scanner glass.
only. Do not use liquid or aerosol cleaners. Do not apply any liquid directly on the
scanner glass.
■
Unplug the scanner and the AC adapter, and refer servicing to qualified service
personnel under the following conditions: The power cord or plug is damaged;
liquid has entered the scanner or the AC adapter; the scanner or the AC adapter has
been dropped or the case damaged; the scanner or the AC adapter does not operate
normally or exhibits a distinct change in performance. (Do not adjust controls that
are not covered by the operating instructions.)
personnel under the following conditions: The power cord or plug is damaged;
liquid has entered the scanner or the AC adapter; the scanner or the AC adapter has
been dropped or the case damaged; the scanner or the AC adapter does not operate
normally or exhibits a distinct change in performance. (Do not adjust controls that
are not covered by the operating instructions.)
■
If you are not going to use the scanner for a long period of time, be sure to unplug
the AC adapter from the electrical outlet.
the AC adapter from the electrical outlet.
■
The lamp(s) in this product contain mercury. Please consult your state and local
regulations regarding disposal or recycling. Do not put in the trash.
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or
television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or
television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
WARNING: The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and may cause
interference levels which exceed the limits established by the FCC for this equipment. It
is the responsibility of the user to obtain and use a shielded equipment interface cable
with this device. If this equipment has more than one interface connector, do not leave
cables connected to unused interfaces. Changes or modifications not expressly approved
by the manufacturer could void the user’s authority to operate the equipment.
equipment will invalidate the FCC Certification of this device and may cause
interference levels which exceed the limits established by the FCC for this equipment. It
is the responsibility of the user to obtain and use a shielded equipment interface cable
with this device. If this equipment has more than one interface connector, do not leave
cables connected to unused interfaces. Changes or modifications not expressly approved
by the manufacturer could void the user’s authority to operate the equipment.
For Canadian Users
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Causing Equipment Regulations.
4103539_b0_00.fm Page 4 Tuesday, December 6, 2005 11:04 AM