Infocus IN2112 ユーザーガイド

3

Important Operating Considerations for Safety

•

Refer to this guide for proper startup and shutdown procedures.

•

Follow all warnings and cautions in this manual and on the projector.

•

Place the projector in a horizontal position no greater than 8 degrees off 

axis.

•

Locate the projector at least 4' (1.2m) away from any heating or cooling 

vents.

•

Do not block ventilation openings. Locate the projector in a well-

ventilated area without obstructions to intake or exhaust vents. Do not 

place the projector on a tablecloth or other soft covering that may block 

the vents.

•

Do not place the projector in direct sunlight, humid, greasy or dusty 

places or in places where the projector may come into contact with 

smoke or steam.

•

Do not look directly into the lens while the projector is being used.

•

Do not drop the projector.

•

Do not spill liquid on the projector. Spilled liquid may damage the 

projector.

•

Use the power cord provided. Connect the power cord to a receptacle 

with a protective safety (earth) ground terminal. A surge-protected 

power strip is recommended.

•

Do not overload wall outlets.

•

When disconnecting the power cord, hold the plug, not the cord.

•

Wash hands after handling the cables supplied with this product.

•

The projector remote control uses batteries. Make sure the batteries’ 

polarity (+/-) is aligned correctly. Dispose of used batteries in 

accordance with local disposal laws.

•

Use an InFocus approved ceiling mount kit for proper fitting, 

ventilation and installation.  The warranty does not cover any damage 

caused by use of non-approved ceiling mount kits or by installing in an 

improper location. 

•

When the projector is ceiling mounted, wear protective eyewear to 

prevent eye injury before opening lamp door.

•

Refer all service to qualified service personnel. Servicing your own 

projector can be dangerous to you and will void the warranty.

•

Only use replacement parts specified by InFocus.  Unauthorized 

substitutions may result in fire, electrical shock, or injury, and may 

void the warranty

•

Only genuine InFocus lamps are tested for use in this projector. Use of 

non InFocus lamps may cause electrical shock and fire, and may void 

the projector warranty. 

•

Hg – Lamp contains mercury. Manage in accordance with local 

disposal laws. See www.lamprecycle.org.

•

The projector uses a high-pressure mercury glass lamp.  The lamp may 

fail prematurely, or it may rupture with a popping sound if jolted, 

scratched, or handled while hot.  The risk of lamp failure or rupture 

also increases as the lamp age increases; please replace the lamp when 

you see the “Replace Lamp” message.

•

In the unlikely event of a lamp rupture, particles may exit through the 

projector vents. Keep people, food, and drinks out of the "keep out" 

area under and around the projector, as indicated by the "X" areas 

below.

Follow these instructions to help ensure image quality and lamp life over 

the life of the projector. Failure to follow these instructions may affect the 

warranty. For complete details of the warranty, see the Warranty Booklet.