Zotac ZBOX HD-ID11 ユーザーガイド

ページ / 18
   
15    
ZOTAC ZBOX
Using your ZOTAC ZBOX
Configuring wireless connection
To connect to a wireless network, follow the instructions below:
1.  Double-click the crossed wireless network icon (pic) on 
       the notification area.
2.  Select the wireless network you want to connect to 
       from the list and click Connect.
3.  After connection was established, you will see 
       Connected.
 Connect the supplied wireless antenna to your ZOTAC 
       ZBOX to enhance wireless signal reception.
 For security concerns, Do NOT connect to an 
       unsecured network, otherwise, the transmitted 
       information without encryption might be visible to 
       others.
 Enter the network security key if necessary.
Configuring wired connection
Using a static IP
1.  Right-click the network icon on the 
       notification area and select Open 
       Network Connections.
2.  Right-click Local Area Connection and 
       select Properties.
3.  Highlight Internet protocol (TCP/IP) and 
       click Properties.
4.  Select Use the following IP address.
5.  Enter your IP address, subnet mask and 
       Default gateway.
6.  If needed, enter the preferred DNS server address.
7.  After entering all of the related values, click OK to finish the configuration.
        • Realtek PCIE network Driver
        • Atheros Wireless driver
 Each driver must be installed individually to ensure proper operation of the 
      ZOTAC ZBOX.
3.    Select the driver you want to install. The driver installer should launch.
4.    Follow the onscreen instructions to install the drivers.
5.    Restart the system.