Uniden d1680 ユーザーガイド

Unpack all handsets,  

battery 

packs, and 

battery 

covers. If 

you need to 

remove a 

cover, press in on the notch and 

slide the cover down and off.
Line up the battery connector 

with the jack inside the handset; 

the connector only fits one way. 
Push the connector in until 

it clicks into place; tug gently 

on the wires to make sure the 

battery is securely connected.
Replace the battery cover and 

slide it into place.
Use an AC adapter to connect 

the power jack on the base to a 

regular indoor (120V AC) power 

outlet. Connect any chargers the 

same way. 
Place a handset in the base with 

the display facing forward. If 

the display doesn’t light up, 

reseat the handset or connect 

the base to a different outlet. For 

2 or more handsets, place each 

handset in a charger. 

1.

2.

3.

4.

5.

6.



Use the telephone cord to connect 

the 

 jack on the base to a 

standard telephone wall jack.
Test the Connection

Pick up the handset and press 

. The handset sounds a dial 

tone, and the display shows 

. 

If you don't hear a dial tone or 

the display says 

check the connection between 

the base and the phone jack. 

Make a quick test call. (Press 

 

to hang up.) 

If you keep hearing a dial tone, 

change to pulse dialing.
If there’s a lot of noise, check 

for interference (see p. 17 ). 

Test all handsets the same way. 

If you can't get a dial tone, move 

the handset closer to the base. 

Your phone uses tone dialing by 

default. If your phone company uses 

pulse dialing, you need to change 

your phone’s dial mode.

On a handset, press 

 

and choose 

.

Select 

 then 

. 

You’ll hear a confirmation tone. 

To send DTMF tones during a call 

(e.g., for an automated response 

system), press 

 to temporarily 

switch to tone dialing. When you 

hang up, the phone automatically 

returns to pulse dialing.

1.

–

2.

–

–

3.

1.

2.