Sonance ct8 インストール手順
Page 3
CT8
33-4200 04/06
• In hard-to-access plenums or retrofi t installations requir-
ing backcans, CT8 loudspeakers can be installed using
a blind-mount enclosure (Atlas Sound BMT95-8 Series
or similar). These enclosures have mounting facilities
for screw mount speaker models. Please refer to the
manufacturer’s specifi cations for more information.
a blind-mount enclosure (Atlas Sound BMT95-8 Series
or similar). These enclosures have mounting facilities
for screw mount speaker models. Please refer to the
manufacturer’s specifi cations for more information.
If a situation should arise which cannot be resolved
through the information contained in these installation
instructions or notes, please contact SOUND ADVANCE
Customer Support Services at (800) 592-4644 or
(949) 492-5449 Monday-Friday 8 AM to 5 PM Pacifi c Time.
FAX (949) 361-5151
through the information contained in these installation
instructions or notes, please contact SOUND ADVANCE
Customer Support Services at (800) 592-4644 or
(949) 492-5449 Monday-Friday 8 AM to 5 PM Pacifi c Time.
FAX (949) 361-5151
LOUDSPEAKER CONNECTION:
GENERAL NOTES:
•
Always allow suffi cient slack for attachment to the
transformer tap pigtails or other connection points as
required.
required.
• Take care not to cut the insulation or otherwise damage
the wiring when tightening the cable clamp.
the wiring when tightening the cable clamp.
•
Avoid dripping solder onto any portion of the loud-
speaker.
70.7V/100V INSTALLATION
1. Connect the black pigtail wire from the transformer
primary to the ground (common, or ‘–’) lead from the
amplifi er.
primary to the ground (common, or ‘–’) lead from the
amplifi er.
2. Choose the appropriate trans-
former power wire (see chart to the
right) and attach it to the ‘+’ lead
from the amplifi er.
former power wire (see chart to the
right) and attach it to the ‘+’ lead
from the amplifi er.
NOTE: Do not use the white trans-
former wire in a 100V installation.
former wire in a 100V installation.
3. Secure the connections using a
suitable method such as wire nuts,
crimps, or solder/shrink tubing as
required by local codes.
suitable method such as wire nuts,
crimps, or solder/shrink tubing as
required by local codes.
•
Fold-over and securely tape any
unused transformer power wires
making sure that the bare leads
do not touch each other or the
speaker backcan assembly. Insure
that all wiring does not touch the
loudspeaker surface.
making sure that the bare leads
do not touch each other or the
speaker backcan assembly. Insure
that all wiring does not touch the
loudspeaker surface.
8-OHM INSTALLATION
1. Cut the transformer secondary wires as indicated in
the diagram below.
the diagram below.
2. Strip ¼” – ½” of insulation from the wires that remain
connected to the speaker (not the ones connected to the
transformer).
connected to the speaker (not the ones connected to the
transformer).
3. Connect the black wire to the common (‘–’) lead from
the amplifi er; connect the red wire to the ‘+’ lead from the
amplifi er.
the amplifi er; connect the red wire to the ‘+’ lead from the
amplifi er.
4. Secure the connections using a suitable method such
as wire nuts, crimps, or solder/shrink tubing as required
by local codes.
as wire nuts, crimps, or solder/shrink tubing as required
by local codes.
•
Fold-over and securely tape all transformer wires making
sure that the bare leads do not touch the connections from
the amplifi er to the speaker.
the amplifi er to the speaker.
Cut Secondary
Wires Here