EIKI LC-X7 ユーザーガイド

Open the battery 

compartment lid.

Install new batteries into 

the compartment.

Replace the 

compartment lid.

For correct polarity (+ and –), 

be sure battery terminals are 

in contact with pins in the 

compartment.

To ensure safe operation, please observe the following precautions :
 

●

  Use two (2) AA or LR6 type alkaline batteries.

 

●

  Always replace batteries in sets.

 

●

  Do not use a new battery with a used battery.

 

●

  Avoid contact with water or liquid.

 

●

  Do not expose the remote control to moisture or heat.

 

●

  Do not drop the remote control.

 

●

  If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

 

●

  Risk of an explosion if battery is replaced by an incorrect type. 

 

●

  Dispose of used batteries according to the instructions.

Point the remote control toward the projector (to 

Infrared Remote Receivers) when pressing the buttons. 

Maximum operating range for the remote control is 

about 16.4’ (5 m) and 60 degrees in front and rear of the 

projector.

Infrared Remote Receivers are provided both in front and 

back of the projector. You can conveniently use both of 

the receivers (pp. 10, 52)

16.4’
(5 m)

The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside 

of the operating range (16.4’/ 5 m). Connect the remote control and the projector with the remote control cable.  Connected 

with the remote control cable, the remote control does not emit wireless signal.

16.4’
(5 m)

Pull up the lid 

and remove it.

✔