EIKI LC-X7 ユーザーガイド

ページ / 84
4
CAUTION: TO  REDUCE  THE  RISK  OF  ELECTRIC 
SHOCK,  DO  NOT  REMOVE  COVER  (OR 
BACK) .  NO  USER-SERVICEABLE  PARTS 
INSIDE  EXCEPT  LAMP  REPLACEMENT .  
REFER SERVICING TO QUALIFIED SERVICE 
PERSONNEL .
THIS  SYMBOL  INDICATES  THAT  DANGEROUS 
VOLTAGE  CONSTITUTING  A  RISK  OF  ELECTRIC 
SHOCK IS PRESENT WITHIN THIS UNIT.
THIS  SYMBOL  INDICATES  THAT  THERE  ARE 
IMPORTANT  OPERATING  AND  MAINTENANCE 
INSTRUCTIONS  IN THE  OWNER’S  MANUAL WITH 
THIS UNIT.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Before installing and operating the projector, read this 
manual thoroughly.
The projector provides many convenient features and 
functions. Operating the projector properly enables you to 
manage those features and maintains it in good condition for 
many years to come.
Improper operation may result in not only shortening the 
product life, but also malfunctions, fire hazard, or other 
accidents.
If your projector seems to operate improperly, read this 
manual again, check operations and cable connections and 
try the solutions in the “Troubleshooting” section in the 
back of this booklet. If the problem still persists, contact the 
dealer where you purchased the projector or the service 
center.
Safety Precaution
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC 
SHOCK, DO NOT EXPOSE THIS APPLIANCE 
TO RAIN OR MOISTURE .
–  This projector produces intense light from the projection 
lens. Do not stare directly into the lens, otherwise eye 
damage could result. Be especially careful that children 
do not stare directly into the beam.
–  Install  the  projector  in  a  proper  position.  Otherwise  it 
may result in a fire hazard.
–  Allowing the proper amount of space on the top, sides, 
and  rear  of  the  projector  cabinet  is  critical  for  proper 
air  circulation  and  cooling  of  the  unit. The  diagrams 
shown  here  indicates  the  minimum  space  required. 
If  the  projector  is  to  be  built  into  a  compartment  or 
similarly  enclosed,  these  minimum  distances    must  be 
maintained.
 – Do not cover the ventilation slots on the projector. Heat 
build-up can reduce the service life of your projector, and 
can also be dangerous.
–  If the projector is unused for an extended time, unplug 
the projector from the power outlet.
CAUTION
Not  for  use  in  a  computer  room  as  defined  in  the 
Standard for the Protection of Electronic Computer/Data 
Processing Equipment, ANSI/NFPA 75. 
NOTE: 
This symbol and recycle system are applied only to EU countries 
and not applied to the countries in the other area of the world.
Your  EIKI  product  is  designed  and 
manufactured with high quality materials 
and components which can be recycled 
and reused.
This  symbol  means  that  electrical  and 
electronic equipment, at their end-of-life, 
should  be  disposed  of  separately  from 
your household waste.
Please dispose of this equipment at your local community 
waste collection/recycling centre.
In  the  European  Union  there  are  separate  collection 
systems for used electrical and electronic products.
Please help us to conserve the environment we live in! 
 
CAUTION ON HANGING FROM THE CEILING
 When  hanging  the  projector  from  the 
ceiling,  clean  the  air  intake  vents  and 
top  of  the  projector  periodically  with  a 
vacuum cleaner. If you leave the projector 
unclean for a long time, the cooling fans 
can  be  clogged  with  dust,  and  it  may 
cause a breakdown or a disaster.
DO  NOT  SET THE  PROJECTOR  IN  GREASy, WET,  OR 
SMOKy  CONDITIONS  SUCH  AS  IN  A  KITCHEN TO 
PREVENT A  BREAKDOWN  OR A  DISASTER .  IF THE 
PROJECTOR  COMES  IN  CONTACT  WITH  OIL  OR 
CHEMICALS, IT MAy BECOME DETERIORATED .
READ AND  KEEP THIS  OWNER'S  MANUAL  FOR  LATER 
USE .
3.3' (1m)
3.3' (1m)
3.3' (1m)
3.3' (1m)
SIDE and TOP
REAR
Ne  peut  être  utilisé  dans  une  salle  d’ordinateurs  telle 
que  définie  dans  la  norme ANSI/NFPA  75  Standard  for 
Protection  of  Electronic  Computer/Data  Processing 
Equipment. 
To The Owner