EIKI LC-X7 ユーザーガイド

Check the number of lamp to be replaced on the Lamp 

Status Display.

Loosen a screw on the Lamp Cover. Slide and open the 

Lamp Cover until it makes a clicking sound. (See the right 

figure.)

Loosen two screws and pull out the Lamp to be replaced 

by grasping handle.

Turn off the projector, press the Main On/Off Switch to Off 

and unplug the AC power cord from the AC outlet.  Let 

the projector cool for at least 45 minutes.

Replace the Lamp with a new one and tighten two 

screws.  Make sure the Lamp is set properly.

Follow these steps to replace the lamp.

Put the Lamp Cover back and tighten a screw. 

Connect  the AC Power Cord to the projector and turn on 

the projector.

Reset the Lamp Replacement Counter. (Refer to section 

"Resetting the Lamp Counter" on page 62.)

NOTE :   Do not reset LAMP REPLACEMENT COUNTER when 

lamp is not replaced.

SCREW

LAMP 
COVER

SCREWS

Make sure which number of lamp needs to be 
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 1.

LAMP 2

LAMP 1

For continued safety, replace with a lamp assembly 

of the same type.

Do not drop the lamp assembly or touch a glass 

bulb! The glass can shatter and may cause injury.

Allow the projector to cool, for at least 45 minutes 

before you open Lamp Cover.  The inside of the 

projector can become very hot.

TURN OFF THE UV LAMP BEFORE 

OPENING THE LAMP COVER.

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the 

screen and LAMP 1/2 REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing 

when the LAMP 1/2 REPLACE indicators should light is depending on the lamp mode.

Lamp replacement icon

✔