EIKI LC-X7 ユーザーガイド

  This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin 

face of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the 
same  rating,  marked  thus 

.  If  the  fuse  cover  is  detachable,  never  use  the  plug  with  the  cover  omitted.  If  a 

replacement fuse cover is required, ensure it is of the same colour as that visible on the pin face of the plug (i.e. 
red or orange). Fuse covers are available from the Parts Department indicated in your User Instructions.

  If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.
  The end of the flexible cord should be suitably prepared and the correct plug fitted.

 

The Wires in this mains lead are coloured in accordance with the following code:

   

Green-and-yellow ············· Earth

   

Blue ································· Neutral

   

Brown ······························ Live

  As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings 

identifying the terminals in your plug proceed as follows:

  The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the 

letter E or by the safety earth symbol   or coloured green or green-and-yellow.

  The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured 

black.

  The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured 

red.

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.  

AC Power Cord used in the United States and Canada is listed by the Underwriters 

Laboratories (UL) and certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug.  This is a safety feature to be sure 

that  the  plug  will  fit  into  the  power  outlet.  Do  not  try  to  defeat  this  safety  feature. 

Should you be unable to insert the plug into the outlet, contact your electrician.

This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  A  digital  device, 

pursuant to Part 15 of FCC Rules.  These limits are designed to provide reasonable protection against 

harmful  interference  when  the  equipment  is  operated  in  a  commercial  environment. This  equipment 

generates,  uses,  and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in  accordance 

with  the  instruction  manual,  may  cause  harmful  interference  to  radio  communications.    Operation  of 

this equipment in a residential area is likely to cause harmful interference in which case the user will be 

required to correct the interference at his own expense.
Do  not  make  any  changes  or  modifications  to  the  equipment  unless  otherwise  specified  in  the 

instructions.  If such changes or modifications should be made, you could be required to stop operation 

of the equipment.

This  is  a  Class A  product.    In  a  domestic  environment  this  product  may  cause  radio  interference  in 

which case the user may be required to take adequate measures. 

This Class A digital apparatus meets all requirements of the Canadian ICES-003.

GROUND