TallyGenicom LA48N ユーザーガイド

Using Set-Up Mode

5-35

The Hex Dump mode prints data and commands in hexadecimal characters and ab-
breviated control codes. The ASCII characters are used for printing. No characters 
are printed for hexadecimal codes 7F to FF. The Hex Dump mode is useful for check-
ing whether your computer is sending the correct commands to the printer and 
whether the printer is executing the commands correctly. It is also useful for debug-
ging software programs.

To start the Hex Dump mode, make sure that continuous forms paper is loaded into 
the printer. Enter the Set-Up mode and follow these steps:

Start the Hex Dump mode (select the HEX-DUMP option).
Repeatedly press the 

 button to position the red cursor under HEX-DUMP, 

and then press the   button or the   button. The printer selects (underlines) 
HEX-DUMP, enters the Ready state and prints a header at the top of the page.

Print the hex dump.
To start hex dump printing, send your file or program to the printer.  The printer 
goes online and prints the hex dump. Press the Pause button to pause and resume 
printing in Hex Dump mode.  To resume hex dump printing, press the Pause but-
ton again.
To print another hex dump, send another file to the printer.

Exit the Hex Dump mode.
Turn the printer off to exit the Hex Dump mode.