TallyGenicom 2440 ユーザーガイド
Special mode
Using the Diagnostic Functions
4-19
Using the Diagnostic Functions
Print Configuration Function
This function prints a list of all the printer’s currently selected values. This function is use-
ful for checking the printer settings when you first enter the Set-Up mode or just before
you exit.
ful for checking the printer settings when you first enter the Set-Up mode or just before
you exit.
1
To enter the Printer Configuration mode:
a) Make sure that the tractors are loaded with continuous feed paper and that the
paper select lever is set forward.
b) Turn the printer off.
c) Turn the printer back on while pressing the PARK/PRINT key.
a) Make sure that the tractors are loaded with continuous feed paper and that the
paper select lever is set forward.
b) Turn the printer off.
c) Turn the printer back on while pressing the PARK/PRINT key.
2
The printer starts to print a list of the currently selected values. The pre-selected fac-
tory settings are shown on the opposite page.
tory settings are shown on the opposite page.
3
To exit the Printer Configuration mode: After the printer has finished printing the list
of values, the printer will automatically restart in the power-up state.
of values, the printer will automatically restart in the power-up state.
Press the SEL/MENU/EXIT key to stop printing. Pressing the key again will resume print-
ing. Press the FF/LOAD key in the pause state to execute a form feed.
ing. Press the FF/LOAD key in the pause state to execute a form feed.