TallyGenicom 6300 クイック設定ガイド

Feed paper
between the lid
and the top of
the printer.

Horizontal Vernier Wheel

Step E. Unlock the right tractor and move it so that the paper's holes align directly over the tractor pins, making sure that the paper is straight,

then close the tractor door.  Gently push the tractor to the right until the paper is smooth. Unlock the left tractor and, keeping the paper reason-

ably taut, holding onto both tractors, move the paper to the left or the right until it is roughly aligned with the desired mark on the Column

Alignment Scale. Lock both tractors.

Step A. Raise the printer lid and open the doors on both tractors.

Step B. Place the stack of paper inside the cabinet on the floor and

feed the paper up through the paper slot, a little ways past the

tractors and through the gap between the top back of the printer

and the lid. It will flow out between the paper chains and fold into

the wire rack near the floor.

Step C. Place the left-side paper holes onto the left tractor pins and close

the tractor door.

The paper falls
into the wire
rack.

Paper Slot

Step D. The Column Alignment Scale is on the top of the hammer bank

housing. Column 1 of pre-printed forms or the left-hand perforation of

plain paper should be aligned with the mark on the scale the forms creator

has designated. The scale is for general guidance. The operator will deter-

mine which scale mark works best with their forms.

Column Alignment Scale

Fine tune the Column Alignment: Rotate the

Horizontal Vernier Wheel, which is located on

the right end of the shaft on which the tractors

ride. Depending upon the direction the paper

needs to move, you will rotate the wheel either

upwards or downwards. Use this wheel to get

the paper perfectly positioned horizontally.

Step F. Set the Top of the Form (TOF). This is done from the Control

Panel. If the printer is not on, turn it on now. Press the Online key until

“Offline” is displayed. Use the up or down arrows to move the perforation

line on the paper to be aligned with the nubbin on the tractor door.

Once the paper is positioned, press the TOF key.

Step G. Set the Print Gap. If the Print Gap Detect Mode is set to “auto”,

an initial Print Gap setting appropriate for the thickness of the paper that

has been loaded will have been automatically determined when you

pressed the TOF key. You may press the "+" or "-" Print Gap key to fine

tune this setting (see chapter 2 of the Operator Manual). Press Clear. Use

the Arrow and Enter keys to select Menu => Test Menu => Pattern =>

Print => Upper. Press Enter to begin running a print test. Press Enter to

halt the test. Examine what has been printed.  Faded print indicates too

wide a gap and smeared ink indicates too narrow a gap. Repeat Step G

until the print is crisp and dark, with no smearing.

Tractors

Open

Locking

Lever

Nubbin for
Top of Form
Alignment

- - - - - - - - - - - - - - - -

086184 - 6300 Series Quick Start Guide