Fujifilm S3100 オーナーマニュアル
Blinking red
Lit red
!
@
#
No icon
＊
17
Using
the
Camera
2
16
Still image shooting
Movie recording
Auto
Scene Position
Manual
Movie
Movie
Photography
0
Flash pop-up button
Press the Flash pop-up button to release the flash.
0
Photography mode selector
Turn the Mode dial to change Photography
mode.
mode.
0
ON/OFF and Photography /
Playback mode selector switch
Playback mode selector switch
Use the Power switch to select the mode.
CHECKING THE BATTERY CHARGE
1 There is ample battery charge.
2 There is insufficient charge left in the batteries.
2 There is insufficient charge left in the batteries.
The batteries will soon run out. Have a new set
of batteries ready.
of batteries ready.
3 The batteries are depleted. The display will
shortly go blank and the camera will stop
working. Replace or recharge the batteries.
working. Replace or recharge the batteries.
Turn the camera on and check the battery charge.
“
C
” appears as a small icon on the right-hand
side of the screen. “
V
” appears as a large icon
on the screen.
●
!
Depending on the camera mode and the type of batteries used, the transition from “
C
” to “
V
” may occur more
quickly.
●
!
Due to the nature of the battery, the battery low warning may appear early when the camera is used in cold
locations. This is normal. Try warming the batteries in your pocket or a similar location before use.
locations. This is normal. Try warming the batteries in your pocket or a similar location before use.
✽ Battery level warning
1) The camera’s estimation of the remaining battery charge varies greatly depending on the camera operation mode.
1) The camera’s estimation of the remaining battery charge varies greatly depending on the camera operation mode.
Consequently, even if “
C
” or “
V
” is not displayed in Playback mode, one of them may appear when you change
to Photography mode.
2) Depending on the battery type and the level of charge in the batteries, the camera may run out of power without first
displaying a battery level warning. This is particularly to happen when batteries that have run out of charge once are
re-used.
In situation 2), immediately load new or fully charged replacement batteries.
re-used.
In situation 2), immediately load new or fully charged replacement batteries.
Lit red
１６
１６
Ｎ
Blinking red
１６
１６
Ｎ
◆
Power save function
◆
When this function is active, it also turns off the screen (sleep mode) to reduce power consumption if
the camera is not used for 60 seconds (
the camera is not used for 60 seconds (
➡P.61). If the camera is then left unused for 2 or 5 minutes, the
Power save function turns the camera off. To turn the camera back on, set the Power switch to “OFF”
briefly and then back to “
briefly and then back to “
q
” or “
w
”.
BASIC OPERATION GUIDE
2
Using
the Camera
the Camera
This section describes the camera’s functions.