Alcatel-Lucent 6850-48 補足マニュアル

Quick Steps for Logging Into the Switch

Logging Into the Switch

page 2-4

OmniSwitch AOS Release 6 Switch Management Guide

The following procedure assumes that you have set up the switch as described in your OmniSwitch Getting 
Started Guide and Hardware Users Guide. Setup includes:

• Connecting to the switch via the console port.

• Setting up the Ethernet Management Port (EMP) through the switch’s boot prompt.

• Enabling (or “unlocking”) management interfaces types (Telnet, FTP, HTTP, SNMP, and Secure Shell) 

through the 

 command for the interface you are using. Note that Telnet, FTP, and 

Secure Shell are used to log into the switch’s Command Line Interface (CLI). For detailed information 
about enabling session types, see 

1 If you are connected to the switch via the console port, your terminal will automatically display the 
switch login prompt. If you are connected remotely, you must enter the switch IP address in your Telnet, 
FTP, or Secure Shell client (typically the IP or IPv6 address of the EMP). The login prompt then displays.

2 At the login prompt, enter the admin username. At the password prompt, enter the switch password. 
(Alternately, you may enter any valid username and password.) The switch’s default welcome banner will 
display, followed by the CLI prompt.

Welcome to the Alcatel-Lucent OmniSwitch 6000

Software Version 6.3.1.733.R01 Development, October 05, 2007.

Copyright(c), 1994-2007 Alcatel-Lucent. All Rights reserved.

OmniSwitch(TM) is a trademark of Alcatel-Lucent registered

in the United States Patent and Trademark Office.

You are now logged into the CLI. For information about changing the welcome banner, see 

.

For information about changing the login prompt, see 

For information about setting up additional user accounts locally on the switch, see