Alcatel-Lucent 6850-48 ネットワークガイド

Configuring IPMVLAN

Configuring IP Multicast VLAN

page 43-12

OmniSwitch AOS Release 6 Network Configuration Guide

The following subsections describe how to create and delete a receiver port in an IPMVLAN with the 

 command.

To create a receiver port in an IPMVLAN configured in the Enterprise mode, use the 

 command as shown below:

-> vlan ipmvlan 1003 receiver-port port 1/51

In the VLAN Stacking mode, the port that you want to configure as a receiver port should be a VLAN 
Stacking User Network Interface (UNI). To create a receiver port in an IPMVLAN configured in the 
VLAN Stacking mode, use the VLAN Stacking ethernet-service command and the vlan ipmvlan 
receiver-port command, as shown below:

-> ethernet-service ipmvlan 1003

-> vlan ipmvlan 1003 receiver-port port 1/49

Note that in the above example, port 1/49 was previously configured as a VLAN Stacking UNI. For more 
information about how to configure a UNI, see 

To delete a receiver port from an IPMVLAN in the Enterprise or VLAN Stacking mode, use the no form 
of the 

 command by entering no vlan ipmvlan followed by the IPMVLAN 

ID, the keyword receiver-port, and the port number, as shown below:

-> no vlan ipmvlan 1003 receiver-port port 1/51

To associate an IPMVLAN with a customer VLAN (CVLAN), use the 

 command. Note 

that configuring a customer VLAN tag for an IPMVLAN is not supported in the Enterprise mode. For 
example, the 

 VLAN Stacking command is used to create the IPMVLAN and then the 

vlan ipmvlan ctag command configures the CVLAN tag for the IPMVLAN: 

-> ethernet-service ipmvlan 1002

-> vlan ipmvlan 1002 ctag 10 

For more information about configuring IPMVLANs in VLAN Stacking mode, see