Alcatel-Lucent 6850-48 ネットワークガイド
Port Monitoring Overview
Diagnosing Switch Problems
page 45-6
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
Quick Steps for Configuring Port Monitoring
1 To create a port monitoring session, use the
command by entering port
monitoring, followed by the port monitoring session ID, source, and the slot and port number of the
port to be monitored. For example:
port to be monitored. For example:
-> port monitoring 6 source 2/3
2 Enable the port monitoring session by entering port monitoring, followed by the port monitoring
session ID, source, the slot and port number of the port to be monitored, and enable. For example:
session ID, source, the slot and port number of the port to be monitored, and enable. For example:
-> port monitoring 6 source 2/3 enable
3 Optional. Configure optional parameters. For example, to create a file called “monitor1” for port moni-
toring session 6 on port 2/3, enter:
toring session 6 on port 2/3, enter:
-> port monitoring 6 source 2/3 file monitor1
Note. Optional. To verify the port monitoring configuration, enter
,
followed
by the port monitoring session ID number. The display is similar to the one shown below:
-> show port monitoring status
Session
Monitor
Monitor
Overwrite Operating Admin
slot/port Direction
Status
Status
----------+----------+----------+--------------+----------+--------------------
6.
2/ 3
Bidirectional ON ON ON
For more information about this command, see
or the “Port Mirroring
and Monitoring Commands” chapter in the OmniSwitch CLI Reference Guide.