Alcatel-Lucent 6850-48 ネットワークガイド
Diagnosing Switch Problems
Port Monitoring
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 45-25
Configuring a Port Monitoring Session
To configure a port monitoring session, use the
command by entering port
monitoring, followed by the user-specified session ID number, source, the slot number of the port to be
monitored, a slash (/), and the port number of the port.
monitored, a slash (/), and the port number of the port.
For example, to configure port monitoring session 6 on port 2/3 enter:
-> port monitoring 6 source 2/3
Note. One port monitoring session can be configured per chassis or stack.
In addition, you can also specify optional parameters shown in the table below. These parameters must be
entered after the slot and port number.
entered after the slot and port number.
For example, to configure port monitoring session 6 on port 2/3 and administratively enable it, enter:
-> port monitoring 6 source 2/3 enable
These keywords can be used when creating the port monitoring session or afterwards. See the sections
below for more information on using these keywords.
below for more information on using these keywords.
Enabling a Port Monitoring Session
To disable a port monitoring session, use the
command by entering port
monitoring, followed by the user-specified session ID number, source, the slot number of the port to be
monitored, a slash (/), the port number of the port, and enable. For example, to enable port monitoring
session 6 on port 2/3, enter:
monitored, a slash (/), the port number of the port, and enable. For example, to enable port monitoring
session 6 on port 2/3, enter:
-> port monitoring 6 source 2/3 enable
Disabling a Port Monitoring Session
To disable a port monitoring session, use the
command by entering port monitoring,
followed by the port monitoring session ID and pause. For example, to disable port monitoring session 6,
enter:
enter:
-> port monitoring 6 disable
Deleting a Port Monitoring Session
To delete a port monitoring session, use the no form of the
command by entering no
port monitoring, followed by the port monitoring session ID. For example, to delete port monitoring
session 6, enter:
session 6, enter:
-> no port monitoring 6
keywords
file
no overwrite
bidirectional
disable
no overwrite
bidirectional
disable
no file
inport
timeout
inport
timeout
size
outport
enable
outport
enable