Alcatel-Lucent 6850-48 ネットワークガイド

Diagnosing Switch Problems

sFlow

OmniSwitch AOS Release 6 Network Configuration Guide

page 45-33

 command is used to display the receiver table. 

For example, to view the sFlow agent table, enter the show sflow agent command without specifying any 
additional parameters. A screen similar to the following example will be displayed, as shown below:

-> ip interface 

Loopback0 127.0.0.1

-> show sflow agent

Agent Version  = 1.3; Alcatel-Lucent; 6.1.1

Agent IP       = 127.0.0.1

Note. For more information about the displays that result from these commands, see the OmniSwitch CLI 
Reference Guide.

To delete a sFlow receiver session, use the release form at the end of the 

 command by enter-

ing sflow receiver, followed by the receiver index and release. For example, to delete sFlow receiver 
session 6, enter:

-> sflow receiver 6 release

To delete a sFlow sampler session, use the no form of the 

 command by entering no sflow 

sampler, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the 
port number of the port, enter:

-> no sflow sampler 1 2/3

To delete a sFlow poller session, use the no form of the 

 command by entering no sflow 

poller, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port 
number of the port, enter:

-> no sflow poller 3 1/1