Alcatel-Lucent 6850-48 ネットワークガイド

Configuring VPLS

Configuring VPLS Services

OmniSwitch AOS Release 6 Network Configuration Guide

page 11-19

A VPLS service is identified by a service ID number and is associated with an existing customer ID 
number. Both ID numbers are assigned when the service is created using the 

 command. For example, the following command creates a service with an ID of 100 and associates 

that service with customer ID 10:

-> configure service vpls 100 customer 10 create

Once created, the service ID is then used to bind the service to an SDP and a SAP on each local and 
remote router for the service. See 

 and 

 for more information.

Optionally configure a description for the service using the 

 command. 

For example:

-> configure service vpls 100 description “cust10-vpls100”

The following VPLS parameter values are set by default at the time the service is created. If necessary, use 
the specified commands to change the default values.

Refer to the OmniSwitch CLI Reference Guide for more information about the above VPLS parameters 
and related commands.

By default, the VPLS service is disabled when the service is created. Once service parameters and SAP 
and SDP bindings are configured, use the 

 command with the no shut-

down option. For example, the following command enables VPLS 100:

-> configure service vpls 100 no shutdown

To disable the service, enter the following command:

-> configure service vpls 100 shutdown

Before deleting a service from the switch configuration, disable the administrative status of the service and 
remove any SDPs and SAPs bound to the service. Once this is done, use the no form of the 

 command to delete the service. For example:

-> configure service no vpls 10

Default VC ID for each end of the 
MPLS tunnel for the service.

VPLS service ID 
is used as the 
default VC ID

MAC flush message sent on port or 
Service Access Point (SAP) failure.

Disabled

The service MTU

1514