Alcatel-Lucent 6850-48 ネットワークガイド

ページ / 1162
Sample Ethernet Ring Protection Configuration
Configuring ERP
page 14-20
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
Example ERP Configuration Steps
The following steps provide a quick tutorial for configuring the ERP ring network shown in the diagram 
on 
Configure ERP ring 1 and add protected VLANs 11 through 20 on Switch A, B, C, D, and E using the 
following commands:
-> erp-ring 1 port1 2/1 port2 2/2 service-vlan 10 level 2
-> erp-ring 1 enable
-> erp-ring 1 protected-vlan 11 - 20
Configure Switch C as the RPL owner for the ring using the following commands to designate port 2/1 
as the RPL port:
-> erp-ring 1 disable
-> erp-ring 1 rpl-node port 2/1
-> erp-ring 1 enable
Verify the ERP ring configuration on any switch using the following command:
-> show erp ring 1
Legend: *  - Inactive Configuration
Ring Id                 : 1,
Ring Port1              : 2/1,
Ring Port2              : 1/2,
Ring Status             : enabled,
Service VLAN            : 10,
WTR Timer (min)         : 5,
Guard Timer (centi-sec) : 50,
MEG Level               : 2,
Ring State              : idle,
Ring Node Type          : rpl,
RPL Port                : 2/1,
Last State Change       : SUN DEC 25 06:50:17 2016 (sysUpTime 00h:01m:31s)
The above output example shows that ERP ring 1 is created on ring ports 2/1 and 1/2 with service VLAN 
10, WTR timer of 5 mins, Guard timer of 50 centi-seconds, MEG level 2, and port 2/1 is the RPL port. 
Verify that VLANs 11 through 20 are protected VLANs for ERP ring 1 using the following command:
-> show erp ring 1 protected-vlan
Ring Id               : 1,
Protected VLAN        : 11-20,
Verify the status of an ERP ring port on any switch using the following command:
-> show erp port 1/2
Legend: * - Inactive Configuration
Ring-Id : 1
  Ring Port Status     : forwarding,
  Ring Port Type       : non-rpl,
  Ethoam Event         : disabled
The above command shows the forwarding status of the port, the type of ring port (RPL or non-RPL), and 
ETHOAM event status.