Alcatel-Lucent 6850-48 ネットワークガイド
Configuring UDLD
UDLD Overview
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 17-5
Mechanisms to Detect Unidirectional Links
The UDLD protocol is
implemented to correct
certain assumptions made by other protocols, and to help
the Spanning Tree Protocol to function properly to avoid the creation of dangerous Layer 2 loops.
UDLD uses two basic mechanisms:
• It advertises the identity of a port and learns about its neighbors. This information about the neighbors
is maintained in a cache table.
• It sends continuous echo messages in certain circumstances that require fast notifications or fast re-
synchronization of the cached information.
Neighbor database maintenance
UDLD learns about other UDLD neighbors by periodically sending a Hello packet (also called an adver-
tisement or probe) on every active interface to inform each device about its neighbors.
tisement or probe) on every active interface to inform each device about its neighbors.
When the switch receives a Hello message, the switch caches the information until the age time expires. If
the switch receives a new Hello message before the aging of an older cache entry, the switch replaces the
older entry with the new one.
the switch receives a new Hello message before the aging of an older cache entry, the switch replaces the
older entry with the new one.
Whenever an interface is disabled and UDLD is running, or
UDLD is disabled on an interface, or the
switch is reset, UDLD clears all the existing cache entries for the interfaces that are affected by the
config-
uration change. UDLD sends a
message to the neighbors to flush the part of their caches affected by the
status change. The message is intended to synchronize the caches.
Echo detection
UDLD depends on an echo-detection mechanism. UDLD restarts the detection window on its side of the
connection and sends echo messages in response to the request, whenever a UDLD device learns about a
new neighbor or receives a re-synchronization request from an out-of-sync neighbor. This behavior is the
same on all UDLD neighbors because the sender of the echoes expects to receive an echo as a response.
connection and sends echo messages in response to the request, whenever a UDLD device learns about a
new neighbor or receives a re-synchronization request from an out-of-sync neighbor. This behavior is the
same on all UDLD neighbors because the sender of the echoes expects to receive an echo as a response.
If the detection window ends and no valid response is received, the link will be shut down, depending on
the UDLD mode. When UDLD is in normal mode, the link is
the UDLD mode. When UDLD is in normal mode, the link is
considered to be undetermined and will not
be shut down. When UDLD is in aggressive mode, the link is considered to be unidirectional, and the
interface is shut down.
interface is shut down.
In normal mode, if UDLD is in the advertisement or in the detection phase and all the neighbor cache
entries are aged out, UDLD restarts the link-up sequence to re-synchronize with potentially out-of-sync
neighbors.
entries are aged out, UDLD restarts the link-up sequence to re-synchronize with potentially out-of-sync
neighbors.
In aggressive mode, if UDLD is in the advertisement or in the detection phase and all the neighbors of a
port are aged out, UDLD restarts the link-up sequence to re-synchronize with potentially out-of-sync
neighbors. UDLD shuts down the port, after the continuous messages, if the link state is undetermined.
port are aged out, UDLD restarts the link-up sequence to re-synchronize with potentially out-of-sync
neighbors. UDLD shuts down the port, after the continuous messages, if the link state is undetermined.