Alcatel-Lucent 6850-48 ネットワークガイド

Quick Steps for Configuring Dynamic Link Aggregation

Configuring Dynamic Link Aggregation

page 23-4

OmniSwitch AOS Release 6 Network Configuration Guide

Follow the steps below for a quick tutorial on configuring a dynamic aggregate link between two switches. 
Additional information on how to configure each command is given in the subsections that follow.

1 Create the dynamic aggregate group on the local (actor) switch with the 

 command as 

shown below:

-> lacp linkagg 2 size 8 actor admin key 5

2 Configure ports (the number of ports should be less than or equal to the size value set in step 1) with 
the same actor administrative key (which allows them to be aggregated) with the 

 command. For example:

-> lacp agg 1/1 actor admin key 5

-> lacp agg 1/4 actor admin key 5

-> lacp agg 3/3 actor admin key 5

-> lacp agg 5/4 actor admin key 5

-> lacp agg 6/1 actor admin key 5

-> lacp agg 6/2 actor admin key 5

-> lacp agg 7/3 actor admin key 5

-> lacp agg 8/1 actor admin key 5

3 Create a VLAN for this dynamic link aggregate group with the vlan command. For example:

-> vlan 2 port default 2

4 Create the equivalent dynamic aggregate group on the remote (partner) switch with the 

 command as shown below:

-> lacp linkagg 2 size 8 actor admin key 5

5 Configure ports (the number of ports should be less than or equal to the size value set in step 4) with 
the same actor administrative key (which allows them to be aggregated) with the 

 command. For example:

-> lacp agg 2/1 actor admin key 5

-> lacp agg 3/1 actor admin key 5

-> lacp agg 3/3 actor admin key 5

-> lacp agg 3/6 actor admin key 5

-> lacp agg 5/1 actor admin key 5

-> lacp agg 5/6 actor admin key 5

-> lacp agg 8/1 actor admin key 5

-> lacp agg 8/3 actor admin key 5

6 Create a VLAN for this dynamic link aggregate group with the vlan command. For example:

-> vlan 2 port default 2