Alcatel-Lucent 6850-48 ネットワークガイド

Configuring Dynamic Link Aggregation

Modifying Dynamic Link Aggregate Group Parameters

OmniSwitch AOS Release 6 Network Configuration Guide

page 23-17

To remove the user-configured actor switch system ID from a dynamic aggregate group’s configuration 
use the no form of the 

 command by entering lacp linkagg followed by the 

dynamic aggregate group number and no actor system id.

For example, to remove the user-configured system ID from dynamic aggregate group 4 you would enter:

-> lacp linkagg 4 no actor system id

By default, the dynamic aggregate group partner administrative key (i.e., the administrative key of the 
partner switch) is 0. The following subsections describe how to configure a user-specified value and how 
to restore the value to its default value with the 

You can modify the dynamic aggregate group partner administrative key to a value ranging from 0 to 
65535 by entering lacp linkagg followed by the dynamic aggregate group number, partner admin key, 
and the value for the administrative key, which can be 0 through 65535.

For example, to set the partner administrative key to 4 on dynamic aggregate group 4 you would enter:

-> lacp linkagg 4 partner admin key 10

To remove a partner administrative key from a dynamic aggregate group’s configuration use the no form 
of the lacp linkagg partner admin key command by entering lacp linkagg followed by the dynamic 
aggregate group number and no partner admin key.

For example, to remove the user-configured partner administrative key from dynamic aggregate group 4 
you would enter:

-> lacp linkagg 4 no partner admin key

By default, the dynamic aggregate group partner system priority is 0. The following subsections describe 
how to configure a user-specified value and how to restore the value to its default value with the

You can modify the dynamic aggregate group partner system priority to a value ranging from 0 to 65535 
by entering lacp linkagg followed by the dynamic aggregate group number, partner system priority, and 
the new priority value.

For example, to set the partner system priority on dynamic aggregate group 4 to 2000 you would enter:

-> lacp linkagg 4 partner system priority 2000

To restore the dynamic aggregate group partner system priority to its default (i.e., 0) value use the no form 
of the 

 command by entering lacp linkagg followed by the dynamic 

aggregate group number and no partner system priority.