Alcatel-Lucent 6850-48 ネットワークガイド
Configuring Dynamic Link Aggregation
Modifying Dynamic Link Aggregate Group Parameters
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 23-23
Modifying Dynamic Aggregate Partner Port Parameters
This section describes how to modify the following dynamic aggregate partner port parameters:
• Partner port system administrative state (see
)
• Partner port administrative key (see
)
• Partner port system ID (see
• Partner port system priority (see
• Partner port priority (see
)
All of the commands to modify partner port parameters allow you to add the ethernet, fastethernet, and
gigaethernet keywords before the slot and port number to document the interface type or make the
command look consistent with early-generation Alcatel-Lucent CLI syntax. However, these keywords do
not modify a port’s configuration. See
gigaethernet keywords before the slot and port number to document the interface type or make the
command look consistent with early-generation Alcatel-Lucent CLI syntax. However, these keywords do
not modify a port’s configuration. See
for information on config-
uring Ethernet ports.
Note. A port may belong to only one aggregate group. In addition, mobile ports cannot be aggregated. See
for more information on mobile ports.
Modifying the Partner Port System Administrative State
The system administrative state of a dynamic aggregate group partner (i.e., remote switch) port is indi-
cated by bit settings in Link Aggregation Control Protocol Data Unit (LACPDU) frames sent by this port.
By default, bits 0 (indicating that the port is active), 1 (indicating that short timeouts are used for
LACPDU frames), and 2 (indicating that this port is available for aggregation) are set in LACPDU frames.
cated by bit settings in Link Aggregation Control Protocol Data Unit (LACPDU) frames sent by this port.
By default, bits 0 (indicating that the port is active), 1 (indicating that short timeouts are used for
LACPDU frames), and 2 (indicating that this port is available for aggregation) are set in LACPDU frames.
The following subsections describe how to configure user-specified values and how to restore them to
their default values with the
their default values with the
command.
Configuring Partner Port System Administrative State Values
To configure the dynamic aggregate partner port’s system administrative state values by entering lacp
agg, the slot number, a slash (/), the port number, partner admin state, and one or more of the keywords
shown in the table below or none:
agg, the slot number, a slash (/), the port number, partner admin state, and one or more of the keywords
shown in the table below or none:
Keyword
Definition
active
Specifies that bit 0 in LACPDU frames is set, which indicates that the
link is able to exchange LACPDU frames. By default, this bit is set.
link is able to exchange LACPDU frames. By default, this bit is set.
timeout
Specifies that bit 1 in LACPDU frames is set, which indicates that a
short time-out is used for LACPDU frames. When this bit is disabled, a
long time-out is used for LACPDU frames. By default, this bit is set.
short time-out is used for LACPDU frames. When this bit is disabled, a
long time-out is used for LACPDU frames. By default, this bit is set.
aggregate
Specifies that bit 2 in LACPDU frames is set, which indicates that the
system considers this link to be a potential candidate for aggregation. If
this bit is not set, the system considers the link to be individual (it can
only operate as a single link). By default, this bit is set.
system considers this link to be a potential candidate for aggregation. If
this bit is not set, the system considers the link to be individual (it can
only operate as a single link). By default, this bit is set.