Alcatel-Lucent 6850-48 ネットワークガイド

VRRPv3 Application Example

Configuring VRRP

page 32-30

OmniSwitch AOS Release 6 Network Configuration Guide

In addition to providing redundancy, VRRPv3 can assist in load balancing outgoing traffic. The figure 
below shows two virtual routers with their hosts splitting traffic between them. Half of the hosts are 
configured with a default route to virtual router 1’s IPv6 address (

213:100:1::56

), and the other half are 

configured with a default route to virtual router 2’s IPv6 address (

213:100:1::57

).

The CLI commands used to configure this setup are as follows:

1 First, create two VRRPv3 virtual routers for VLAN 5. (Note that VLAN 5 must already be created and 
available on the switch.)

-> vrrp3 1 5

-> vrrp3 2 5

2 Configure the

 

IPv6 addresses for each VRRPv3

 

virtual router.

-> vrrp3 1 5 address 213:100:1::56

-> vrrp3 2 5 address 213:100:1::57

3 Enable the VRRPv3 virtual routers.

-> vrrp3 1 5 enable

-> vrrp3 2 5 enable

213:100:1::56

213:100:1::57

213:100:1::57

213:100:1::56

default gateway 10.10.2.250

default gateway 10.10.2.245