Alcatel-Lucent 6850-48 ネットワークガイド

Creating Policies

Configuring QoS

page 40-32

OmniSwitch AOS Release 6 Network Configuration Guide

Note. (Optional) To verify that the rule has been configured, use the show policy rule command. The 
display is similar to the following:

-> show policy rule

Policy               From  Prec Enab   Act Refl Log Trap Save

r1 

cli     0  Yes   Yes   No  No  Yes  Yes

(L2/3):                               cond1 -> action1

r2 

 cli     0  Yes   Yes   No  No  Yes  Yes

(L2/3):                               cond2 -> action4

+r3                                cli     0  Yes   Yes   No  No  Yes  Yes

(L2/3):                               cond3 -> action2

This command displays information about whether or not the indicated parameter may be used to classify 
traffic based on policies that are configured on the switch. For more information about this display, see 

An example of how the example configuration commands might display when entered sequentially on the 
command line is given here:

-> policy condition cond3 source ip 10.10.2.3

-> policy action action2 priority 7

-> policy rule my_rule condition cond3 action action2

-> qos apply

When the policy rule, policy condition, and policy action commands as well as any of the condition 
group commands are configured and saved in an ASCII file (typically through the snapshot command), 
the commands included in the file will include syntax indicating the command’s origin. The origin speci-
fies where the rule, condition, condition group, or action was created, either an LDAP server or the CLI 
(from ldap or from cli). For built-in QoS objects, the syntax displays as from blt. For example:

-> policy action A2 from ldap disposition accept

The from option is configurable (for LDAP or CLI only) on the command line; however, it is not recom-
mended that a QoS object’s origin be modified. The blt keyword indicates built-in; this keyword cannot be 
used on the command line. For information about built-in policies and QoS groups, see 

.