Alcatel-Lucent 6850-48 ネットワークガイド
Configuring IPMSv6 on a Switch
Configuring IP Multicast Switching
page 42-24
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
Configuring IPMSv6 on a Switch
This section describes how to use Command Line Interface (CLI) commands to enable and disable IPv6
Multicast Switching (IPMSv6) switch wide (see
Multicast Switching (IPMSv6) switch wide (see
), configure a port as an MLD static neighbor (see
), configure a port as an MLD static querier (see
), and configure a port as an MLD static group (see
Note. See the “IP Multicast Switching Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation of IPMSv6 CLI commands.
complete documentation of IPMSv6 CLI commands.
Enabling and Disabling IPv6 Multicast Status
IPv6 Multicast is disabled by default on a switch. The following subsections describe how to enable and
disable IPv6 Multicast by using the
disable IPv6 Multicast by using the
command.
Note. If IPv6 Multicast switching and routing is enabled on the system, the VLAN configuration over-
rides the system’s configuration.
rides the system’s configuration.
Enabling IPv6 Multicast Status
To enable IPv6 Multicast switching and routing on the system if no VLAN is specified, use the
command as shown below:
-> ipv6 multicast status enable
You can also enable IPv6 Multicast switching and routing on the specified VLAN by entering:
-> ipv6 multicast vlan 2 status enable
Disabling IPv6 Multicast Status
To disable IPv6 Multicast switching and routing on the system if no VLAN is specified, use the
command as shown below:
-> ipv6 multicast status disable
Or, as an alternative, enter:
-> ipv6 multicast status
To restore the IPv6 Multicast status to its default setting.
You can also disable IPv6 Multicast on the specified VLAN by entering:
-> ipv6 multicast vlan 2 status disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 status
To restore the IPv6 Multicast status to its default setting.