Alcatel-Lucent 6850-48 ネットワークガイド

Configuring IPMSv6 on a Switch

Configuring IP Multicast Switching

page 42-28

OmniSwitch AOS Release 6 Network Configuration Guide

You can configure a port as an MLD static group by entering 

followed by 

the IPv6 address of the MLD static group in hexadecimal notation separated by colons, a space, followed 
by vlan, a space, VLAN number (which must be between 0 and 4095), a space, followed by port, the slot 
number of the port, a slash (/), and the port number.

For example, to configure an MLD static group with an IPv6 address of 

ff05::5

 enter:

-> ipv6 multicast static-group ff05::5 vlan 3 port 3/10

You can also configure a link aggregation group as an MLD static group by entering 
ipv6 multicast static-group, followed by vlan, a space, VLAN number (which must be between 0 and 
4095), a space, followed by port, a space, and the link aggregation group number.

For example, to configure link aggregation group 7 with designated VLAN 2 as a static group you would 
enter:

-> ipv6 multicast static-group ff05::6 vlan 2 port 7

To reset the port so that it is no longer an MLD static group port, use the no form of the 

command by entering no ipv6 multicast static-group, followed by the IPv6 

address of the static group in hexadecimal notation separated by colons, a space, followed by vlan, a 
space, VLAN number, a space, followed by port, a space, the slot number of the port, a slash (/), and the 
port number.

For example, to remove an MLD static member with an IPv6 address of 

ff05::5 

on port 10 in slot 3 with 

designated VLAN 3 you would enter:

-> no ipv6 multicast static-group ff05::5 vlan 3 port 3/10