Alcatel-Lucent 6850-48 参照ガイド
MPLS LDP Commands
OmniSwitch CLI Reference Guide
September 2009
page 24-23
configure router ldp maximum-recovery-time
Configures the Maximum Recovery Time value for the local LDP router. This time value specifies the
amount of time the router retains stale MPLS label-forwarding equivalence class (FEC) bindings received
from a neighboring LDP router as the result of a graceful restart process.
amount of time the router retains stale MPLS label-forwarding equivalence class (FEC) bindings received
from a neighboring LDP router as the result of a graceful restart process.
configure router ldp maximum-recovery-time seconds
configure router ldp no maximum-recovery-time
Syntax Definitions
seconds
The Maximum Recovery Time value, in seconds. The valid range is
from 15–1800.
from 15–1800.
Defaults
By default, the Maximum Recovery Time is set to 120 seconds.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
• Use the no form of this command to set the Maximum Recovery Time to the default value.
• If the neighboring router advertises a Recovery Time that is less than the local Maximum Recovery
Time value, then the local router applies the Recovery Time to the stale label-FEC bindings it receives
from that same router instead of the Maximum Recovery time value.
from that same router instead of the Maximum Recovery time value.
Examples
-> configure router ldp maximum-recovery-time 300
-> configure router ldp no maximum-recovery-time
Release History
Release 6.4.2; command was introduced.