Alcatel-Lucent 6850-48 参照ガイド
MPLS LDP Commands
page 24-66
OmniSwitch CLI Reference Guide
September 2009
show router ldp parameters
Displays the global LDP parameter values (graceful restart, interface, and targeted session) for the local
router.
router.
show router parameters
Syntax Definitions
N/A.
Defaults
N/A.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
The interface parameters displayed with this command are global values that serve as default values for
individual LDP interfaces. Note that parameter values configured for a specific interface override the
global values.
individual LDP interfaces. Note that parameter values configured for a specific interface override the
global values.
Examples
->show router ldp parameters
LDP Parameters (LSR ID 10.10.0.7)
Graceful Restart Parameters
Fwd State Hold Time (sec): 120,
Reconnect Time (sec):
120,
Nbor Liveness Time (sec): 120,
Max Recovery Time (sec): 120
Interface Parameters
Keepalive Timeout (sec):
30,
Keepalive Factor:
3,
Hold Time (sec):
15,
Hello Factor:
3,
Propagate Policy:
system,
Transport Address:
system,
Deaggregate FECs:
False,
Route Preference:
9,
Label Distribution:
downstreamUnsolicited, Label Retention:
liberal,
Control Mode: ordered, Loop Detection:
none
Targeted Session Parameters
Keepalive Timeout (sec): 40, Keepalive Factor:
4,
Hold Time (sec): 45, Hello Factor:
3,
Passive Mode: False, Targeted Sessions: Enabled
output definitions
Graceful Restart Parameters:
Fwd State Hold Time (sec)
The amount of time, in seconds, that the LDP router retains its MPLS
forwarding state after a graceful restart. Configured through the
forwarding state after a graceful restart. Configured through the
command.