Alcatel-Lucent 6850-48 参照ガイド
Virtual Private LAN Service (VPLS) Commands
page 26-60
OmniSwitch CLI Reference Guide
September 2009
configure service vpls sap create
Configures a Service Access Point (SAP) by associating a SAP ID with a Virtual Private LAN Service
(VPLS). A SAP ID is comprised of a customer-facing port (referred to as an access port) and an encapsu-
lation value that is used to identify the type of customer traffic to map to the associated service.
(VPLS). A SAP ID is comprised of a customer-facing port (referred to as an access port) and an encapsu-
lation value that is used to identify the type of customer traffic to map to the associated service.
configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] create
configure service vpls service-id no sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1]
Syntax Definitions
service-id
An existing VPLS ID number.
slot/port1
The slot and port number of the service access port.
agg_num
The link aggregate ID number (0–31) of a service access link aggregate.
:0
Specifies a null encapsulation value for the SAP. Depending on the pre-
configured encapsulation type for the access port, a SAP using a null
encapsulation will direct tagged and untagged or only untagged traffic to
the associated service.
configured encapsulation type for the access port, a SAP using a null
encapsulation will direct tagged and untagged or only untagged traffic to
the associated service.
:all
Specifies a wildcard SAP. All tagged or untagged traffic that is not clas-
sified into another SAP is mapped to the wildcard SAP. Not config-
urable on null encapsulation access ports.
sified into another SAP is mapped to the wildcard SAP. Not config-
urable on null encapsulation access ports.
:qtag1
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
Defaults
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
• To specify a SAP ID, use the slot/port and linkagg agg-num parameters combined with the :0, :qtag,
or :all parameters. For example, enter 1/2:all to specify the SAP on access port 1/2 that maps all traffic
to this service that is not already mapped to other SAPs.
to this service that is not already mapped to other SAPs.
• Use the no form of this command to remove a a SAP.
• Specify only ports or link aggregates that are configured as service access ports (see
). This command does not apply to network ports.
• The encapsulation mode for the access port determines how many SAPs are allowed on the access port.
If the port is set to null encapsulation, only one default SAP is allowed on the port. If the port is set to
parameter
default
:0 | :all | :qtag1
:0 (null)