Alcatel-Lucent 6850-48 参照ガイド
Virtual Private LAN Service (VPLS) Commands
page 26-76
OmniSwitch CLI Reference Guide
September 2009
show service port
Displays the access (customer-facing) port configuration for the router.
show service port [slot/port | linkagg agg_num]
Syntax Definitions
slot/port
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
module (e.g., 3/1 specifies port 1 on slot 3).
agg-num
The link aggregate ID number (0–31).
Defaults
By default, all service access ports are displayed if a port or link aggregate number is not specified.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
• Use the slot/port and linkagg agg-num parameters to display the configuration for a specific port or
link aggregate.
• Access ports are required to configure a Service Access Point (SAP). A SAP is the point at which
customer traffic enters and exits the provider service. SAPs are not configured on network ports
Examples
-> show service port
Port Table
Port Admin Link Cfg Oper Port Port L2Profile
Id Status Status MTU MTU Mode Encp
-------+------+------+------+------+-----+-----+--------------------------------
8/7 Down Down 1528 1528 accs null def-access-profile
8/8 Up Up 9212 9212 accs null DropBPDU
8/9 Up Down 9212 9212 accs dotq Tunnel-Amap
0/19 Up Up 9212 9212 accs null def-access-profile
Number of Ports : 4
-> show service port 8/9
Port Table
Port Admin Link Cfg Oper Port Port L2Profile
Id Status Status MTU MTU Mode Encp
-------+------+------+------+------+-----+-----+--------------------------------
8/9 Up Down 9212 9212 accs dotq Tunnel-Amap
Number of Ports : 1