Alcatel-Lucent 6850-48 参照ガイド
802.1AB Commands
OmniSwitch CLI Reference Guide
September 2009
page 27-17
lldp tlv med
Specifies the switch to control per port LLDP-MED (Media Endpoint Device) TLVs to be incorporated in
the LLDPDUs.
the LLDPDUs.
lldp {slot/port | slot | chassis} tlv med {power | capability} {enable | disable}
Syntax Definitions
slot/port
Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
(e.g., 3/1 specifies port 1 on slot 3).
slot
The slot number for a specific module.
power
Enables or disables transmission of LLDP-MED extended POE TLV in
LLDPDU.
LLDPDU.
capability
Enables or disables transmission of LLDP-MED capabilities TLV in
LLDPDU.
LLDPDU.
enable
Enables LLDP-MED TLV LLDPDU transmission.
disable
Disables LLDP-MED TLV LLDPDU transmission.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• The LLDPDU must be enabled and set to transmit before using this command.
• If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
• The lldp tlv med power version of this command applies only to PoE units.
• Before enabling the Power MED TLV, use the
command to activate PoE on a port or
on all ports in a specific slot.
Examples
-> lldp 4/4 tlv med power enable
-> lldp 4/3 tlv med capability enable
-> lldp 4 tlv med power disable
Release History
Release 6.3.1; command was introduced.
parameter
default
enable | disable
disable