Alcatel-Lucent 6850-48 参照ガイド

Chassis MAC Server (CMS) Commands

page 3-2

OmniSwitch CLI Reference Guide

Modifies the default MAC range on the switch’s EEPROM.

Note. Use caution when modifying the default MAC range. Improper use of this command can disable 
your system and adversely affect your network. Contact Alcatel-Lucent Customer Support for further 
assistance.

mac-range eeprom start_mac_address count 

The first MAC address in the modified range. Enter the MAC address in 
the following format: xx:xx:xx:xx:xx:xx, where x is a hex value (0–f).

Specifies the number of MAC addresses in the range (1–256).

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Because the factory-installed 32 MAC addresses are sufficient for most network configurations, this 

command should only be used by qualified network administrators for special network requirements.

• After modifying a MAC address range by using the mac-range eeprom command, you must reboot 

the switch. Otherwise, MAC addresses for existing VLAN router ports will not be allocated properly.

• All MAC addresses in a range must be contiguous (i.e., there cannot be any gaps in the sequence of 

MAC addresses).

-> mac-range eeprom 00:20:da:23:45:35 32

Release 6.1; command was introduced.